MLV-8振动传感器/航振

MLV-8Vibration Velocity Sensor

1．概述

MLV-8振动传感器/航振主要安装在各种旋转机械装置的轴承盖上（如汽轮机、压缩机、风机和泵等）。它是由运动线圈切割磁力线而输出电压的电磁式传感器，因此具有工作时不需要供给电源、安装容易等特点。

1. Overview

The PR-1020 vibration sensor is mainly installed on the bearing housings of various rotating machinery (such as steam turbines, compressors, fans, pumps, etc.). As an electromagnetic sensor that outputs voltage by moving coils cutting magnetic lines, it features no external power supply required for operation and easy installation.When connected with a vibration severity monitor, it can measure various parameters such as displacement and velocity.

2．技术参数

2．1 灵 敏 度: 50mv/mm/s

2. 2 频率响应：10 ～ 1000 Hz ，5 ～ 1000 Hz (特制）    

2. 3 误 差: 10- 300HZ < 2% 

            300- 1000HZ < 4%

2．4 自振频率：10Hz

2．5 可测振幅：≤2mm(P — P)

2．6 最大加速度：10g

2．7 测量方向：水平或垂直

 2．8使用环境： -40℃～100℃ 相对湿度 ≤90%

2．9 外形尺寸：φ33×75mm

2．10 重 量: 约300g

2.11 安装螺钉：M10*1.5

2. Technical Parameters

2.1 Sensitivity: 50 mV/mm/s

2.2 Frequency Response: 10 ~ 1000 Hz; 5 ~ 1000 Hz (custom version)

2.3 Error: < 2% at 10–300 Hz; < 4% at 300–1000 Hz

2.4 Natural Frequency: 10 Hz

2.5 Measurable Amplitude: ≤ 2 mm (P–P)

2.6 Maximum Acceleration: 10 g

2.7 Measuring Direction: Horizontal or vertical

2.8 Operating Environment: -40 ℃ ~ 100 ℃, relative humidity ≤ 90%

2.9 Dimensions: φ33 × 75 mm

2.10 Weight: Approx. 300 g

2.11 Mounting Screw: M10 × 1.5

Two brown and blue wires are signal positive (+); one black wire is the shielding wire.Figure 1 Outline Drawing

3．安 装

3．1 安装位置：垂直或者水平安装于被测振动点上，以变送器底部M8×1.25螺钉磁座吸附在被测壳体上，然后将传感器拧在上面拧紧即可.

3. Installation

3.1 Mounting Position: Install vertically or horizontally at the measured vibration point. Attach the magnetic base with M8 × 1.25 screw at the bottom of the transmitter to the measured housing, then screw the sensor onto it and tighten.

4.注意事项：传感器不能外力重击.

4. Notes

Do not strike or impact the sensor with external force.