渗透剂
Penetrant
渗透剂（JFC）的全称是脂肪醇聚氧乙烯醚，属非离子表面活性剂。渗透剂顾名思义是起渗透作用，也是具有固定的亲水亲油基团，在溶液的表面能定向排列，并能使表面张力显著下降的物质。
The full name of penetrant (JFC) is fatty alcohol polyoxyethylene ether, which is a nonionic surfactant. Penetrant, as its name implies, is also a substance with fixed hydrophilic and lipophilic groups, which are aligned on the surface of solution and can significantly reduce surface tension.
本产品有的附着力，渗透力的液体材料，干燥快，耐磨性强，并有很好的抗化学性及耐水性，该产品通过有效渗透，与混凝土和石造物中的成分发生作用，使混凝土的各成分固化成一个坚固实体，并阻塞了混凝土的各大小细孔，得到一个无尘致密的整体，从而提高混凝土的耐磨性、抗压性、致密性和抗渗性。可满足各种不同的使用需求和环境差异，适合工厂、仓库、码头、停车场等水泥地面的处理，而且颜 色可以无限制调配。
The product has excellent adhesive force, highly permeable liquid material, fast drying, strong abrasion resistance, and good chemical resistance and water resistance. Through effective permeation, the product interacts with components in concrete and stone products to solidify each component of the concrete into a solid entity, block all small and large pores of the concrete, and obtain a dust-free compact whole, thus improving the abrasion resistance, compression resistance, compactness and impermeability of the concrete. It can meet various use requirements and environmental differences, and is suitable for the treatment of cement floors such as factories, warehouses, docks, parking lots and the like, and the color can be adjusted without restriction.
使用方法（Use method）
新地上混泥土密封固化剂大概使用量每加仑17~25平方米,在表面喷雾器或者软毛刷子涂刷均匀,不能破坏地面,无需进一步处理.
The usage amount of concrete seal curing agent on the new ground is about 17~25 square meters per gallon. The surface sprayer or soft hair brush shall be applied evenly, which cannot damage the ground and requires no further treatment.
老水泥地上,用喷雾器或者软毛刷子把未掺水的混泥土密封固化剂涂刷均匀,保持至少30分钟.
On the old cement floor, use a sprayer or a soft-wool brush to evenly brush the un-watered concrete seal curing agent for at least 30 minutes.
注意（Pay attention to）:
1.特别注意多孔或者干的地面,那些地方要混泥土密封固化剂保持湿润,当表面成胶.变光滑为佳,立即洒少量水用刷子,或者机器刷表面混泥土密封固化剂渗透到里层.保持5~10分钟,直到混泥土密封固化剂再次变为胶状,变为光滑,然后十分的清洗干净.如果表面有光滑的残留,说明没有清洗干净,要进一步的清洗.
Special attention should be paid to porous or dry ground. In those places, the concrete seal curing agent should be kept moist. When the surface becomes smooth, it is better to sprinkle a small amount of water with a brush immediately, or machine brush the surface of the concrete seal curing agent to penetrate into the inner layer. Keep for 5-10 minutes until the concrete seal curing agent becomes gelatinous and smooth again, and then clean it thoroughly. If there is any smooth residue on the surface, it means that it has not been cleaned, and further cleaning is required.
2.如果没有的清洗干净那些残留没有反应的混泥土密封固化剂,水泥地表会出现泛白,立即清洗没有反应的残留物质,或者用水抛光地面.
If the residual unreacted concrete seal curing agent is not thoroughly cleaned, the cement surface will whiten. Clean the unreacted residual substances immediately or polish the surface with water.
