| Measurement Principle | Oxygen dependent luminescence quenching |
| Measuring Range | 0 to 2 ppm (0 to 50 mbar) |
| Oxygen Consumption | None |
| Required Flow | None |
| Response Time | < 20 sec in gas; < 90 sec in water |
| Temperature Sensor | NTC 22 kOhm |
| Drift at Room Temperature | < 1 % per week @ 100 ppb |
| Configurable Values | DO: mbar; %-sat; %-vol; µg/l; mg/l; ppb/ppm (gas); ppb/ppm (dissolved oxygen); Temperature: °C, °F, K |
| Autoclavable | No |
| CIP | Yes |
| Steam Sterilizable | Yes, max. temperature 140°C |
| Process Temperature | -10 to 140°C; the Sensor provides no DO reading above 85°C |
| Pressure Range | -1 to 12 bar |
| O-ring Material | EPDM (FDA approved) |
| Surface Quality of Steel | Ra < 0.4 µm (N5) |
| Protection Rating | IP 68 |
| Certificate | Yes, with parameter settings and materials used |
| Serial Number | Yes |
| Diameter | 12 mm |
| Process Connection | PG13,5 |
| Electrical Connector | M12 |
| Analog Interface 1 | 4-20 mA for DO, programmable |
| 4-20 mA Accuracy | 03 current value 005 mA B |
| 4-20 mA Current Range | 3.5 to 22 mA |
| Operating Voltage | 18 to 30 VDC |
| Electrolyte | None |
| Wetted parts | Stainless steel 1.4435, Silicone (FDA approved), EPDM |
| a-length | 120 mm |
| Analog Interface | Two wire sink needs to be powered by external power supply |
| Accuracy at 25°C | ± 0.5 ppb or 2% whichever is greater |
| Membrane / Cap | Delivered with ODO Cap L0 |
