山东赛肯测控技术有限公司
山东赛肯测控技术有限公司
MFM 6100Two-Phase Mass Flow MeterThe Correflow MFM combines the technology of two patented measurement techniques (velocity and concentration) in a single sensor to achieve a measurement of mass flow.
The Correflow MFM combines the technology of two patented measurement techniques (velocity and concentration) in a single sensor to achieve a measurement of mass flow. The first measurement determines the two phase slurry velocity and the second measurement determines the fraction of one of the phases of the mixture in relation to the other. Combining these two parameters yields mass per unit time (ie. mass flow).
Two Component Concentrations: 1% to 99%
Materials: Insulating liquids, solids (particulate), gas (bubbles or as carrier)
Typical Response Time: Concentration–updated at 2.5 millisecond intervals using last measured velocity; Velocity–typically updated once per second
Purge Option: Type Z purged (NEMA 4X): Cl1, Div 2, GR C&D
European (Eex approved) housing also available
Sensor: Typical Sensor Pipe sizes: 1/8" (.32 cm) ID or greater
Pressure limits: 1000 psi (69 bar) typical for small sensors, Higher pressure designs available. No moving parts, no flow restrictions or additional pressure drop
Power Requirements: 115 to 240 VAC, 50 to 60 Hz (100 Watts maximum)
Instrument air for optional pressurization(intermittently 4 scfm @ 80 to 120 psi)
Data Analysis Velocity, volume fraction, mass fraction, mass flow measurements on an instantaneous basis and averaged over user programmed time intervals, Total mass for fixed time intervals, Stream temperature
Calibration Routines: Sensor self-tuning with optional dynamic auto-zeroing routines; Adjustable gain on concentration and velocity measurement circuitry; Adjustable signal filtering on concentration measurement circuitry; Adjustable sampling rate for a wide range of process conditions
Software and fully installed PC available
Sensor connections designed intrinsically safe
Each sensor has Four 4-20mA outputs which are independently
programmable to any Four of 12 available parameters
MODBUS over RS485 or Ethernet communications: communication or data read out for remote parameter adjustment, calibration and testing.
Various digital and analog inputs optionally available
Continuous analysis with selectable time averaging
No moving parts, unaffected by vibration
No additional pressure drop
Selectable output scaling
Designed intrinsically safe
Ruggedized for the factory environment
Instantaneous and average mass flow outputs
Non-contact measurement
MFM6100
您感兴趣的产品PRODUCTS YOU ARE INTERESTED IN
仪表网 设计制作，未经允许翻录必究 .
请输入账号
请输入密码
请输验证码
