深圳市世家仪器有限公司
深圳市世家仪器有限公司
可编程测试，全远程控制自动绝缘耐压测试仪● 绝缘电阻测试(DC50V～1200V)，耐压测试(AC/DC5000V)，全远程控制● 可编程测试(测试程序32个文件，测试点每个文件50步)● 通过PWM控制方法，产生精确的测试电压● 3930高电压扫描单元(选件)
| 输出电压AC/DC | AC0.2～5.00kV,500VA(额定30分钟)/DC0.2～5.00kV,50VA(连续) |
|---|---|
| 电压设置方式 | 数字设置(设置分辨率：0.01kV) |
| AC波形/频率 | 正弦波(无负载时畸变率在5％以下)，可以在50/60Hz切换 |
| 电流测量范围 | 10mA，分辨率：0.01mA / 100mA，分辨率：0.1mA |
| 电压计 | 精度：±1.5%f.s.(JIS 1.5级，f.s.=5.00kV)(有效值显示) |
| 判定方式 | 窗口比较方式(数字设定) |
| 额定电压 | DC50~1200V(1V步进的话可任意设置) |
|---|---|
| 额定测试电流 | 1mA，短路电流：200mA以下 |
| 测试范围/精度 | 0.10 ～9999 MΩ, 4档量程, ±4 % rdg. (代表值 0.5 MΩ～1000 MΩ时) |
| 判定方式 | 窗口比较方式(数字设定) |
| 设置范围 | 0.3～999 s |
|---|---|
| Ramp/Delay | 测试电压Ramp up、down，绝缘电阻试验延迟：0.1～99.9s |
| 功能 | 最多可对32个文件进行50步进的实验设置的编程 各保存10组耐压/绝缘的试验内容，保持，蜂鸣器 |
| 监测功能 | 输出电压、检测电流/测试电阻，监测周期：2次/s以上 |
| 电源 | AC100～240V(50/60Hz)，1000VA max. |
| 体积/重量 | 320W×155H×480D mm,18kg |
| 附件 | 9615高压测试线(高压线和回路，各1)，电源线×1，使用说明书×1，备用保险丝×1 |
Voltage withstanding test part
Output voltage AC/DC AC0.2-5.00kV, 500VA (rated 30 minutes)/DC0.2-5.00kV, 50VA (continuous)
Voltage Setting Mode Digital Setting (Setting Resolution: 0.01 kV)
AC waveform/frequency sinusoidal wave (distortion rate below 5% without load) can be switched at 50/60 Hz
Current measurement range is 10 mA, resolution: 0.01 mA/100 mA, resolution: 0.1 mA.
Voltmeter accuracy: +1.5% F.S. (JIS 1.5, F.S. = 5.00kV) (RMS display)
Decision mode, window comparison mode (digital setting)
Insulation resistance test
Rated voltage DC50~1200V (1V step can be set arbitrarily)
Rated test current 1 mA, short circuit current below 200 mA
The test range/accuracy is 0.10~9999 M_, 4 ranges, +4% rdg. (when the representative value is 0.5 M_~1000 M_)
Decision mode, window comparison mode (digital setting)
Timer * The actual test will result in different timer settings due to different loads
Setting range 0.3-999 s
Ramp/Delay test voltage Ramp up and down, insulation resistance test delay: 0.1-99.9s
Function: Programming of experimental setup of up to 50 steps for 32 files
Preserve 10 groups of test contents of withstanding voltage/insulation, hold, buzzer
Monitoring function: output voltage, detection current/test resistance, monitoring period: more than 2 times/s
Power supply: AC100-240V (50/60Hz), 1000VA max.
Volume/weight 320W*155H*480D mm, 18kg
Annex 9615 High Voltage Test Wire (High Voltage Wire and Loop, 1 each), Power Wire *1, Instruction *1, Standby Fuse *1
您感兴趣的产品PRODUCTS YOU ARE INTERESTED IN
仪表网 设计制作，未经允许翻录必究 .
请输入账号
请输入密码
请输验证码
