荣计达HY-84B水泥快速养护箱厂家 水泥养护箱使用方法

一、水泥快速养护箱产品简介：

水泥快速养护箱是 的水泥快速养护室设备， 水泥快速养护箱是我公司依据行业标准T0509-94《水泥胶砂强度快速试验》设计制造。水泥快速养护箱适用于水泥厂、建筑施工、科研等单位对普通硅酸盐水泥，矿渣水泥，火山灰水泥、粉煤灰水泥的试块进行快速养护。适用于水泥厂，建筑科研施工单位对所有混凝土试件进行快速恒温养护，可在24小时内预测出3天、7天、23天龄期的抗压、抗折试验结果，缩短水泥检验周期。

Product introduction of cement quick curing box:

The cement quick curing box is the fastest cement curing room equipment. The cement quick curing box is designed and manufactured by our company in accordance with the industry standard T0509-94 "Quick Test of Cement Sａnd Strength". The rapid cement curing box is suitable for cement plant, building construction, scientific research and other units for rapid curing of ordinary portlａnd cement, slag cement, pozzolanic cement, and fly ash cement. It is suitable for cement plants, and the construction scientific research and construction units conduct rapid and constant temperature curing of all concrete specimens, and can predict the compression, flexural test results of 3 days, 7 days, and 23 days within 24 hours, shortening the cement inspection cycle.

二、水泥快速养护箱技术参数：

★温控范围：室温0-100℃

★时间控制：0.5-24小时

★加热功率：1000W/220V

★内箱尺寸：B型：550mm×350mm×320mm

★重量：65kg

Second, the technical parameters of the rapid cement curing box:

★ Temperature control range: room temperature 0-100 ℃

★ Time control: 0.5-24 hours

★ Heating power: 1000W / 220V

★ Inner box size: Type B: 550mm × 350mm × 320mm

★ Weight: 65kg

三、水泥快速养护箱使用方法：

★箱体安放平稳后， 先检查电器部分有无原件损坏，线路是否接触良好，插好传感器和加热器插头。设备必须有可靠接地。 　

★开箱加水高约60mm。试块成型后，常温存放7小时或标养3小时，观察接近终凝时，（根据水泥成分不同，应自行注意观察，接近终凝时间）随同试模一起放入箱内搁架上。

★ 盖好箱盖，插好温度传感器，根据各厂水泥成分不同，设定温度和工作时间。

★ 试验结束，取出试模放置常温处，到试块恢复常温时，拆开试模，取出试块，即可进行抗折、抗压试验。

★试验结束后，放水并擦干内箱。

★ 根据水泥种类不同，可采用恒温65-80℃之间进行，标准与快速对比试验10-20次，找出比值或差值，得出标准检验结果

Third, the use of cement rapid curing box:

★ After the cabinet is installed smoothly, first check the electrical parts for damage to the original parts and whether the lines are in good contact. Plug the sensor and heater plugs. The equipment must be reliably grounded.

★ Unpacking and adding water is about 60mm high. After the test block is formed, it is stored for 7 hours at room temperature or 3 hours at standard temperature. When it is observed to be near the final setting, (depending on the composition of the cement, you should pay attention to it and approach the final setting time) and put it on the shelf in the box together with the test mold.

★ Cover the box, insert the temperature sensor, and set the temperature and working time according to the cement composition of each plant.

★ After the test, remove the test mold and place it at normal temperature. When the test block returns to normal temperature, disassemble the test mold and remove the test block to perform the flexural and compressive test.

★ After the test, drain the water and dry the inner box.

★ Depending on the type of cement, a constant temperature of 65-80 ° C can be used. The standard and rapid comparison tests are performed 10-20 times to find the ratio or difference and obtain the standard inspection result.

四、水泥快速养护箱结构：

箱体由内、外箱体和保温层组成。内外箱均采用优质不锈钢焊接成型。内外层之间填充有优质保温层。箱体与箱盖之间采用水槽密封。

Fourth, the structure of cement rapid curing box:

The box body is composed of an inner box and an outer box and an insulation layer. The inner and outer boxes are welded with high-quality stainless steel. The inner and outer layers are filled with a high-quality insulation layer. A water tank seal is used between the box body and the box cover.

五、水泥快速养护箱装箱单：

1、主机： 1台

2说明书合格证：1本

V. Packing list of cement quick curing box:

1. Host: 1

2 instruction certificate: 1